Langdao Silex showed a prototype extreme-ultraviolet light source at the 26th China International Industry Fair in Shanghai and did not switch it on. The company, founded in 2024 by alumni of Tsinghua University's Gas Discharge Plasma Laboratory, rates the FlintNano LPP-OXXO at 15 watts. Tom's Hardware says that figure is the company's, that the booth demo did not prove it, and that a light source is not a lithography scanner.

Tom's Hardware's report from the fair is the only detailed account in this window. The source uses laser-produced plasma, the same family ASML's modern sources use: a laser hits tiny heated metal droplets and the plasma throws off EUV light. Langdao's sheet says the prototype can run more than 100 hours, with plasma stability of 3 percent RMS and EUV output stability of 5 percent. Those numbers, if they hold, fit exposure experiments. They do not fit high-volume chip production. A second design, the FlintMicro-LPP, has finished a proof-of-principle test. Langdao has not published its power, its conversion efficiency, or its lifetime.

Fifteen watts is not yet on ASML's measuring stick

Tom's Hardware's comparison is to the first generation of Western and Japanese sources, with a measurement caveat attached. ASML's early demonstration tools used about 10 watts at intermediate focus in 2007, from a Philips Extreme UV discharge source. Cymer's laser-produced sources in early NXE:3100 tools delivered up to 11 watts during wafer exposures. Later NXE:3400 tools carried 125 to 150 watts at intermediate focus and still were not enough for high-volume manufacturing. ASML's commercial sources reached the 250-watt class in 2018 and 2019.

Langdao has not said whether its 15 watts is measured at the plasma or at intermediate focus, which is where ASML counts usable power. If the 15 watts is at the plasma, the power that would reach a wafer is lower. Tom's Hardware also notes there is no public way to check the 100-hour claim. ASML's third quarter reached $13.06 billion, up 55 percent. That is the company already shipping the scanners this prototype is being compared with. The quarterly sales split is a different story from a source that has not been lit.

Ninety percent domestic is a claim without a denominator

Langdao says 90 percent of the prototype's components are domestically sourced and that most of the critical parts were developed in China. The company has not said whether 90 percent means a count of parts, a share of cost, or something else. Representatives told reporters, in Tom's Hardware's account, that raising output and keeping the source stable are the steps still required before the design can be sold. Even a working source, the article says, could be used for photoresist tests, mask inspection, collector optics, and experimental exposures without a full scanner on the end of it.

Getting from a source to a scanner means collectors, illumination optics, multilayer mirrors, wafer and reticle stages, overlay, and the integration of all of them. Tom's Hardware says that supply chain barely exists in China today. SK Hynix is asking Washington for tool licenses while it plans a U.S. NAND plant. Those are etch and deposition tools for a memory fab that already exists, not an EUV scanner. CXMT's new memory design pulled Micron, Samsung, and Hynix down earlier this week. That was a stock move in memory. Langdao is a light-source booth.

ASML took about six years to climb from 11 watts to 150

Tom's Hardware puts ASML and Cymer's climb from about 11 watts to the 125-to-150-watt class at roughly six years, and those watts were at intermediate focus. A higher-power source also needs a stronger CO2 laser, a precise tin-droplet generator, debris control, a collector mirror that survives, and reliability over a production shift. Langdao has not shown those pieces. The fair demonstration leaves China with a company that will state a wattage and a domestic-content figure, and with no public exposure of a wafer on this tool.